eBay
 

Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

Brand new aftermarket stator

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation
  • Highest grade of lamination materials
  • Highest grade of copper winding, resistant to 200 degrees Celsius
  • Connector included
  • Rubber grommet included
  • All products shipped are tested

*18 pole stator. There are more that one possible stator for the Sportsman 700 Non-EFI 4x4 2004. *The RM01057 OD is 107 mm, ID 41 mm, thickness is 23 mm. Please call for further clarification.

*All item pictures are accurate, if in doubt, do not hesitate to compare our item to your original part.

Vehicle models fitment

 

Polaris Sportsman 700 EFI -- 2004-2006
Polaris Sportsman 800 EFI -- 2005-2006
Polaris Sportsman 800 INTL -- 2007

OEM part replacement

 

4010911

Specifications

 

Dimensions :
Interior diameter : 41 mm
Exterior diameter : 107 mm
Thickness : 23 mm
Length of wires stator to grommet : 130 mm
Length of wires grommet to plug : 1200 mm

Other specifications :
Number of wires : 8
Number of plugs : 3
Number of pins : 8

Wire to wire resistance :
Alternator : Between each Yellow = 0.4 ohms +/-20%

instructions

  Before installing your new stator

  • Check the AC output of the stator
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".

Videos


Watch Evan, head of engineering at RMSTATOR, explaining the installation process behind this product.



Learn more about the great company that is RMSTATORâ„¢.



Learn more why and how to repair melted or corroded connectors.