eBay

Kit Flywheel + Crankcase Cover Gasket for Suzuki LTA 400 Eiger 2002-2007 | 32102-38F00 / 32102-38F01 / 32101-38F00

PLEASE NOTE: This kit will fit ONLY on AUTOMATIC models.

Brand new Kit Flywheel + Crankcase Cover Gasket

  • All products are tested

All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part

Magneto Flywheel Rotor

RMSTATOR is offering a new replacement flywheel for your Suzuki and Arctic Cat. This flywheel can be used as a direct replacement to the OEM.

    What is improved about the RM11502 flywheel?

    2002-2007 Suzuki Eiger 400 and 2003-2008 Arctic Cat 400 ATVs are plagued with problems on the original flywheels. The additives in the motor oil were dissolving the epoxy that holds the magnets in the flywheel, causing them to detach and scatter throughout the engine.

    1 EXPOSED EPOXY
    2 DETACHED MAGNET

    The bad news is that by the time the problem occurred, no manufacturer would provide warranty repairs.

    The good news is that RMSTATOR has manufactured a redesigned flywheel where the magnets are sealed in the flywheel, which reinforces the epoxy and prevents them from detaching. This new flywheel configuration corrects the problem permanently.

    Dealership estimates to repair this failure are over $500 in parts alone. RMSTATOR offers you a high quality replacement part that corrects the problem for half the price. The RM11502 flywheel is not only a cost effective way to replace your failed Suzuki or Arctic Cat flywheel, but a great investment when replaced before the failure occurs.

    3 SEAL THAT PROTECTS THE MAGNET’S EPOXY FROM OIL ADDITIVES

    original-flywheel


    improved-flywheel

Vehicle models fitment

 

Suzuki LTA 400 Eiger -- 2002-2007

OEM part replacement

 

RM22614-R00

Specifications

 

Flywheel

Dimensions:

Exterior Diameter: 143 mm
Interior Diameter: 120 mm
Interior Diameter Center Housing: 18 mm
Exterior Diameter Center Housing: 42 mm
Thickness (exterior): 12 mm
Thickness (interior): 13 mm

instructions

 

Before attempting to start your Arctic Cat or Suzuki, adjusting the air gap is necessary.
Rotate the flywheel so the raised node is lined up with the pick up/pulser coil and adjust as close as possible but no less than 0.010".

Videos




Learn more why and how to repair melted or corroded connectors.