eBay

Voltage Regulator Rectifier for Suzuki GN 125 GN125 / GZ 250 GZ250 1982-2010 # 32800-05300 / 32800-05320 / 32800-29B00

KEY FEATURES
 

Brand new voltage regulator rectifier direct replacement

Improved heat sink and charging capabilities

Higher grade of electric components

All products shipped are tested

DESCRIPTION

 

Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

There are two possible regulators for the 2001 Arctic Cat 250 and 300 models. This regulator fits models up to SERIAL # 305377. For models SERIAL # 305378 and up, the right regulator is part RM30308. Always check in the 'Fits models' section and please compare to your original part before buying.

Brand new voltage regulator rectifier

  • Direct replacement to your original unit.
  • Plug-and-play, direct fit, easy installation.
  • No assembly required
  • The Quality exceeds the OEM equipment
  • Improved heat sink and charging capabilities
  • Higher grade of electric components.
  • All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.

*All item pictures are accurate, if in doubt do not hesitate and compare our item to your original part.

Vehicle models fitment

 

Suzuki GN 125 -- 1982-1983, 1991-1997
Suzuki GN 250 -- 1982-1983, 1988
Suzuki GZ250 -- 1999-2010

OEM part replacement

 

32800-05300
32800-05320
32800-29B00
3430-024
3530-014
32800C29B00J000

Specifications

 

Dimensions :
Width : 50mm
Length : 75mm
Height: 25mm
Fixation holes center to center : 60mm

Other specifications :
Number of plugs : 2
Number of pins : 5
Minimum Charging Voltage: 14.5V +/- 0.5V
Maximum Charging Current: 25A-35A/300W-500W
Open Circuit Voltage: <15V
Operation Temperature: -20? to 85?

instructions

 

Before installing your new regulator/rectifier:

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors.